Project London Bridge

mc turbo · Post by **mc turbo** » Tue Jul 08, 2014 12:50 pm

biznatch wrote:I hadn't thought of that Thomas, might give it a go since I want to do some more fine sanding to the front bumper before spraying. Lucky for me I can check out what it would look like by seeing the pics on your thread

m8 what bumper is that ?? as it looks like my twr bumper but with a lip on it! cheers mick

biznatch · Post by **biznatch** » Tue Jul 08, 2014 9:45 pm

Not sure on the model but I think it's aftermarket. Looks similar to Thomas's spoiler which I have been admiring from afar

. It's sprayed in matt black primer at the moment so should look much better when fully prepped and sprayed.
Elford side skirts and rear spoiler will be added but needs so. Elford minor repairs done first...

spirit r · Post by **spirit r** » Tue Jul 08, 2014 10:28 pm

http://www.ebay.de/itm/KUWE-Verbreiteru ... 3f370eb16f.

Yes same as my spoiler.Without my mods on it.
Thomas

spirit r · Post by **spirit r** » Sun Oct 12, 2014 5:51 pm

You can check the left side of your front bumper KÜWE D134 sign.

: Foto0358.jpg (867.01 KiB) Viewed 6475 times

biznatch · Post by **biznatch** » Mon Oct 13, 2014 10:03 pm

Nearly finished

KiwiDave · Post by **KiwiDave** » Tue Oct 14, 2014 4:50 pm

mmmmmmm. Shiny

biznatch · Post by **biznatch** » Tue Oct 14, 2014 5:27 pm

Shiny but not polished to a mirror finish Dave, only as much as my short attention span could allow. Even to get a nice sheen on the housings and front cover took about 8 hours with all the drill attachments and polishing wheels, compound, etc. I just didn't have the patience to take it any further.

There's still a number of things to finish like oil pump, set end clearance, flywheel and clutch, oil pan etc but it's a bit of a break through getting to this point. It hasn't been without a few setbacks.
I measured the oil pump to have 17.5mm lobes, so it seems this may have been uprated when it was previously rebuilt - result!
I've been taking plenty of photos along the way and will do a write up when time allows, probably in a few weeks.

TOOL · Post by **TOOL** » Tue Oct 14, 2014 6:39 pm

SHOW US THE PORTS

You tease

biznatch · Post by **biznatch** » Tue Oct 14, 2014 9:21 pm

A sneeky peeky at the port-porn here for you Mr Tool

biznatch · Post by **biznatch** » Tue Oct 14, 2014 9:24 pm

Ready for assembly

www.RX7fb.com

Project London Bridge

Re: Project London Bridge

Re: Project London Bridge

Re: Project London Bridge

Re: Project London Bridge

Re: Project London Bridge

Re: Project London Bridge

Re: Project London Bridge

Re: Project London Bridge

Re: Project London Bridge

Re: Project London Bridge