Re: Project 'Dont fear the rotor'
Posted: Sat Apr 12, 2014 9:02 pm
I was looking at the same one last night... what's the quality like? I might get one.
www.RX7fb.com
A Dedicated Forum For The Mazda RX7 FB & SA 1st Generation
http://www.rx7fb.com/
Project 'Dont fear the rotor'
Page 15 of 18
Re: Project 'Dont fear the rotor'
Posted: Sat Apr 12, 2014 9:06 pm
Quality's good, nothing to complain about well worth £30 in my opinion.
Re: Project 'Dont fear the rotor'
Posted: Sat Apr 12, 2014 9:14 pm
I've seen the same one for £20 - I've got what appears to be an identical one as well.
Couple of plates, threaded bar and an ally centre there isn't nothing to go wrong - bargain!
Moon roof looks sweet by the way.
Couple of plates, threaded bar and an ally centre there isn't nothing to go wrong - bargain!
Moon roof looks sweet by the way.
Re: Project 'Dont fear the rotor'
Posted: Sun Apr 13, 2014 2:03 am
Nice info there ... never knew a FC one would fit with a little 'adjustment'. Off to consult EBay now. RX7fb scores again 
Re: Project 'Dont fear the rotor'
Posted: Sun Apr 13, 2014 7:05 am
It's a good, cheap mod.... I've started a new thread off about it so that we can chat about it without clogging Adams car thread up...KiwiDave wrote:Nice info there ... never knew a FC one would fit with a little 'adjustment'. Off to consult EBay now. RX7fb scores again
viewtopic.php?f=8&t=2017
Re: Project 'Dont fear the rotor'
Posted: Sun Apr 13, 2014 10:22 am
Lookin good Adam, I'm a fan of the rear bins.
Re: Project 'Dont fear the rotor'
Posted: Sun May 11, 2014 10:46 pm
Got a few more jobs done on the car this weekend.
Cut some foam to fit around the spare wheel.
Had the us spec bumper painted and fitted it along with the rear trim panel.
Had some square number plates made up and fitted them.
Fitted my extreme rotaries gilmer drive kit.
Cut some foam to fit around the spare wheel.
Had the us spec bumper painted and fitted it along with the rear trim panel.
Had some square number plates made up and fitted them.
Fitted my extreme rotaries gilmer drive kit.
Re: Project 'Dont fear the rotor'
Posted: Mon May 12, 2014 2:04 am
You watched out for the torrington bearing though, right?
Re: Project 'Dont fear the rotor'
Posted: Mon May 12, 2014 10:04 am
Oooh, Gilmer in black looks good. Not seen that before. Rear end is much better too, though the numberplate looks massive 
Is it just the angle the pics taken from?
Is it just the angle the pics taken from?
The do what now?TOOL wrote:You watched out for the torrington bearing though, right?
Re: Project 'Dont fear the rotor'
Posted: Mon May 12, 2014 2:30 pm
Google "pinched torrington bearing".
You can't just take the front pulley off a rotary.
You can't just take the front pulley off a rotary.