www.RX7fb.com

And the full set 'as-is' deffo came complete off an S3.

these are photos I took when I had mine made up.

FRONT


REAR


AND THE 5th ONE on the axle


Hope this helps.

Dibs

Yeah, it does, Dibs. This is the one I ended up with...





So basically it's got female fittings both ends. It needs a female-male adaptor sticking in one end. Something like this http://www.demon-tweeks.co.uk/motorspor ... to-1-8-npt though I'm not 100% certain of the thread size and pitch off the top of my head

isn't the 5th flexible brake hose the same one as the flexible from the clutch hard line to the slave? I think I've interchanged them in the past

Could well be. I'm pretty sure that's what came in my set from Canada. Will check tomorrow.

I am going to order 3 sets of master and slave cylinders for Gen 1 Series 3, for me, Lucky and Dibs. Please confirm.
Kev

Hi Kevin, That would be great. let me know about payment.

Dibs

4 sets please Kevin. I'll have a set as well.

Let me know if you want advance payment and I'll give you my details at the same time.

I don't know what quality you'd choose but I usually go for upper-end parts for Gus........
But what ever arrives will be good.

Regards

Dave

Great stuff! Let me know payment details too, yeah?

Much obliged

Hi,
Order placed delivery expected 1/7/2015.
Total cost including shipping £130
Pay me when they get here.
If you send me a pm with your email addresses I will forward you a copy of the receipt/order.
Cheers
Kevin