Excellent stuff going on there Jess, making the most of Lockdown & the weather You have put some hard work in over the last few years & is now paying off...keep it up, unfortunately I am not likely to see the results until next year
Re: A Kiwis Series 3
Posted: Sun May 17, 2020 6:10 pm
by gt_james
Nice work, hope you cleared out that intake elbow and TB! I'll have to pop by and have a look again after we're allowed to!
Re: A Kiwis Series 3
Posted: Sun May 17, 2020 7:17 pm
by rotarypower
Some excellent work there!
Making me feel bad for slacking now haha.
Re: A Kiwis Series 3
Posted: Sun May 17, 2020 7:48 pm
by Hobbawobba
Thanks guys! It was very slow progress over winter without a unit/garage! But I'm getting there now.
A7RXY wrote: ↑Sun May 17, 2020 5:56 pm
Great write up ... I'm just getting ready to take my axle off, must say I'm not looking forward to it .
Dibs
Let me know if you'd like any pictures of anything in particular! Mine is still all apart
DKWW2000 wrote: ↑Sun May 17, 2020 6:00 pm
unfortunately I am not likely to see the results until next year
Who knows what might happen in the next month or two aye! We might be allowed out
gt_james wrote: ↑Sun May 17, 2020 6:10 pm
Nice work, hope you cleared out that intake elbow and TB! I'll have to pop by and have a look again after we're allowed to!
Yeah the elbow and throttle body got a VERY good clean out after that crap!
rotarypower wrote: ↑Sun May 17, 2020 7:17 pm
Some excellent work there!
Making me feel bad for slacking now haha.
Don't worry about that! This is all work I have done since aaaages ago! September I think?
Re: A Kiwis Series 3
Posted: Mon May 18, 2020 11:19 am
by spirit r
The overcome chickenpox help people getting more strong
Stay save Jess !
Re: A Kiwis Series 3
Posted: Mon May 18, 2020 2:51 pm
by Casey
Great work Jess
Re: A Kiwis Series 3
Posted: Mon Jun 22, 2020 9:52 pm
by Hobbawobba
So close. Hoping to get the diff set up with the help of a friend over the next week or so. Then it'll just be install it all back on the car! I will post a proper update once its back on
Ordered some new gilmer belts as I have gone EWP and needed a shorter belt. Had a leaking fuel hose when I primed my pumps. The quality of fuel hose on the market is so dangerous . 2 completely different hoses I have had to replace. Both 1 year old (8mm and AN6). Decent stuff also! Made up a new hose. Managed to start it up for the first time since around September. Lots of 2 stroke burning off . Premixed quite a lot also. No idle control either, but that doesn't matter after 30 seconds haha. Revving up to about 4500 or so.
Re: A Kiwis Series 3
Posted: Tue Jun 23, 2020 3:36 pm
by spirit r
hard start, bad rev and thin sounding smoke maschine =
You have put some hard work in over the last few years & is now paying off...keep it up, unfortunately I am not likely to see the results until next year 
. 2 completely different hoses I have had to replace. Both 1 year old (8mm and AN6). Decent stuff also! Made up a new hose. Managed to start it up for the first time since around September. Lots of 2 stroke burning off 
