www.RX7fb.com

If you’re still using the block with the ETL and badge on then it’s 1/4” BSP.. I used a 1/4” BSP to AN 4

Many thank yous Victor x

That's an Apex Seal, above the rotor in the rear housing

If anyone wants an entire 12a Elford setup...

Turbo and new HEL oil lines
Exhaust Manifold (original and new 2.5" tube)
Turbosmart 38mm wastegate
Elford Inlet (port matched)
Modified carb wit massive float bowl
Fuel pressure reg
Massive 97glh fuel pump
I've even got the 12AT dizzy so you don't need the poor functioning Elford pressure sensors (which I also have)

Message me 07885635nineninenine

Cheers kids!