Re: Project 'Dont fear the rotor'
Posted: Fri Apr 05, 2013 7:28 pm
Housings and rotors all cleaned up and ready to be built back up.
www.RX7fb.com
A Dedicated Forum For The Mazda RX7 FB & SA 1st Generation
http://www.rx7fb.com/
Project 'Dont fear the rotor'
Page 9 of 18
Re: Project 'Dont fear the rotor'
Posted: Fri Apr 05, 2013 8:21 pm
looking good Adam, what did you clean them up with?
Re: Project 'Dont fear the rotor'
Posted: Fri Apr 05, 2013 8:57 pm
soaked the rotors in clutch and brake cleaner, gets all the carbon off. Cleaned the housings by brushing the cleaner on and wiping it off as it evaporates quickly and the stationary gears are soaking as we speak.
Re: Project 'Dont fear the rotor'
Posted: Sat Apr 06, 2013 7:04 pm
nice new oil cooler arrived.
Re: Project 'Dont fear the rotor'
Posted: Sat Apr 06, 2013 8:55 pm
Where is that from? Does it have a built in bypass? Need a new front mount cooler so interested to know...
Re: Project 'Dont fear the rotor'
Posted: Sun Apr 07, 2013 6:44 pm
Its an oz ebay special. It hasnt got a built in bypass. Its quite a chunky made thing not cheap and nasty.
Re: Project 'Dont fear the rotor'
Posted: Sat Apr 13, 2013 8:03 pm
Bit of cleaning and painting.
Re: Project 'Dont fear the rotor'
Posted: Sat Apr 13, 2013 8:35 pm
are you going to open the ports up while you've got it apart?
Re: Project 'Dont fear the rotor'
Posted: Sun Apr 14, 2013 1:44 pm
We have done a bit of slight porting. 
Re: Project 'Dont fear the rotor'
Posted: Sun Apr 14, 2013 1:45 pm
that a boy 
that port is very turbo bridge like will we see a turbo on it in future ??
Is that your own port design or have you used a template and are all plates ported with the bridge or just the end plates?
that port is very turbo bridge like
will we see a turbo on it in future ??Is that your own port design or have you used a template and are all plates ported with the bridge or just the end plates?