Page 1 of 1
Holley 600 to 12A
Posted: Fri May 30, 2014 2:09 pm
by re japi
My friend is selling Holley 600cmf carburator, for low price. It used to be in smallblock V8. Well, my question is that what I need to modify and change to get it work in my street ported 12A?
Re: Holley 600 to 12A
Posted: Fri May 30, 2014 2:21 pm
by Lucky
Racing Beat offer a manifold that supports a Holley, but if the car is right-hand drive it physically won't fit with the brake servo and stuff
Re: Holley 600 to 12A
Posted: Fri May 30, 2014 4:26 pm
by TOOL
A 600 is a bit big by all accounts, but go for it if the price is right.
You'll just need the appropriate manifold for it.
Re: Holley 600 to 12A
Posted: Fri May 30, 2014 6:23 pm
by re japi
Yes, I thought that its too big. And I imagine I can do manifold my self. Car is left hand drive. But how about Holleys internals, jets and those other crap? Do I have to change them and to what kind?
Re: Holley 600 to 12A
Posted: Fri May 30, 2014 7:11 pm
by TOOL
Dunno. What's it got in it?
Re: Holley 600 to 12A
Posted: Fri May 30, 2014 7:51 pm
by KiwiDave
Racing Beat use a 465 cfm for a stock and street port, 600 cfm and mechanical secondaries for a bridgeport. Modded internals for both.
Re: Holley 600 to 12A
Posted: Sat May 31, 2014 4:08 am
by re japi
TOOL wrote:Dunno. What's it got in it?
I have no idea!
Some crap to make v8 run...
Re: Holley 600 to 12A
Posted: Wed Jul 02, 2014 7:40 pm
by Arcolithe
Not sure if toubwent ahead already
Used holley intake will cost 75-150
2 o rings and intake manifold to housing gasket
Two pair of smaller jets. Preferably .071 on secondaries and .075 on primaries
You need a 2 spacer and low carb hat , spacer should come with gaskets.
Fuel pump that can go up to 6 psi and a fuel tegulator if its too strong.
I suggest steel braid fuel line upgrades as well but not necessary
Re: Holley 600 to 12A
Posted: Thu Sep 25, 2014 11:48 am
by re japi
Another question:
Have anyone tryed to put two little sidedraft webers on 12A??? I have two 40`s and I´m wondering if they will work?
Re: Holley 600 to 12A
Posted: Thu Sep 25, 2014 3:10 pm
by TOOL
Steve put bike carbs on a 12A.
I've got IDAs so I work with them. I've got a 50mm IDA on the shelf, jetted for a 13B PP. I've got a 48 IDA on my 13B BP. They're a really nice carb.
You could try upgrading to a Hitachi 4 bbl off a factory 13B. Hard to find though.