www.RX7fb.com

Good afternoon everyone.

I have not been active on here for a while as my 7 has been garaged up. Now it time to let it out again. I am in the middle of getting everything it needs to get it sorted just now but i need a like info if anyone has got it.

I am have custom springs made and i need some dimensions. Unfortunately i am out the country and can measure this myself. So i was just wondering if anyone is able to measure the outside diameter of the front and rear springs for me.

This is the last bit of info i need to get the springs made up. I am hoping to have everything ordered for the time i get home so i can get cracking on the car.

Any info much appreciated

Scott

The fronts are tapered like an ice cream cone. Not much you can do except run the originals or way overspend on the 40% stiffer lowering springs from RacingBeat. I checked with Moog, no luck.
Because I'm using FC struts, I was able to adapt some other Moogs, at very low cost.
I considered coilovers, but they're too big for the bottom end, and too small for the top end. A bit of fabrication could make it work, but I'm under time constraints and budget constraints.