www.RX7fb.com

Yes i have, i have purchased the 80 imsa wing from them,
But they don't make the 79imsa/group c flares i want to have on the car.

Shifti

I don't have any pictures to show you of the sa22c just yet Lucky. But i will start a build tread when i start working on the car, i have some pictures of my rx7 fd and my mx5 na if you want to see, non of them are like mazda made them originaly.. hehe. I could never get 15x12 et -51 to fit under th...

Hello, not sure if this is in the right section but here goes. So i have been searching around and trying to find out how much toe you should have on the rear axle on the first gen rx7. I think i will go for 1 degree negative camber just to try to get the tire temperatures a little (evener) over the...

Thank you Dave.

Hi Thomas and thank you. :) I am planing to use some RS Watanabe's type r, i think the group c flares widen the car with 100mm each side. I have to measure them when i get them on the car, after i get hold of them. RS Watanabe has three sizes that sould be usable, they are: 10x15 et-25 10,5x15 et-32...

Hello fellow rotary nuts. My name is Einar. I have a 92mod rx7 fd that i have been building on for the last ten years, and is now finaly almost finished. I also have a 80 mod SA22c with a street port 12a i used it as a daily for four years before the rust got so bad i had to stop driving it. now aft...