NA Street Port Apex Seals

Ghostkls · Post by **Ghostkls** » Mon Oct 06, 2014 7:30 am

Thanks Tool!

You always seem to have all the info I am needing! Will probably pic your brain a few more times as the build progresses.

TOOL · Post by **TOOL** » Mon Oct 06, 2014 7:33 am

Well, I am slowly building a S5 street port NA motor. So I've been through this same process recently.

Ghostkls · Post by **Ghostkls** » Mon Oct 06, 2014 8:40 am

What you going to be running? Carb? Fuel Injection?

TOOL · Post by **TOOL** » Mon Oct 06, 2014 10:10 am

I've got a 48 IDA and a 50 IDA available. A 48 will be fine on a street port on the road though.

I've got high comp 9.7:1 rotors going in mine, so it should make good power.

I'll start a thread on my sloooooow build.

Ghostkls · Post by **Ghostkls** » Mon Oct 06, 2014 2:22 pm

Waiting patiently to see your build! Make sure you show all your little secrets!

TOOL · Post by **TOOL** » Mon Oct 06, 2014 9:19 pm

No secrets really. It's all documented on the internet or in books.

Never seen anyone else hand lap though. Not sure if that's good or bad lol.

www.RX7fb.com

NA Street Port Apex Seals

Re: NA Street Port Apex Seals

Re: NA Street Port Apex Seals

Re: NA Street Port Apex Seals

Re: NA Street Port Apex Seals

Re: NA Street Port Apex Seals

Re: NA Street Port Apex Seals