www.RX7fb.com

How do I do this up tight without a 54mm socket???

I used a De Walt 18 V Impact Gun, takes them off on the middle setting. I can not remember the Torque but it is more than ample

DKWW2000 wrote: ↑Wed Oct 07, 2020 5:07 pm I used a De Walt 18 V Impact Gun, takes them off on the middle setting. I can not remember the Torque but it is more than ample

I've got a gun Pete and a big breaker bar but no 54mm socket to go on them... can't think of another way to tighten it up... I loosened it with a cold chisel

Do you need in a hurry....I could send tomorrow? Or a large set of Stilsons

ian65 wrote: ↑Wed Oct 07, 2020 5:24 pm

DKWW2000 wrote: ↑Wed Oct 07, 2020 5:07 pm I used a De Walt 18 V Impact Gun, takes them off on the middle setting. I can not remember the Torque but it is more than ample

I've got a gun Pete and a big breaker bar but no 54mm socket to go on them... can't think of another way to tighten it up... I loosened it with a cold chisel

Cut the conture out of a steel plate and weld it on the breaker bar!

I have one you can borrow if you're down this way anytime soon aye bro. It's a 1" drive I think

Hobbawobba wrote: ↑Thu Oct 08, 2020 9:40 pm I have one you can borrow if you're down this way anytime soon aye bro. It's a 1" drive I think

Thanks Jesse... I'm sorted now.... Pete's dropped his in the post for me so I can torque it up and post it back to him When the autojumbles start again I'll have to buy my own.

I got mine off eBay Ian think it was about £25 posted on a 1" drive

mooragerx7 wrote: ↑Fri Oct 09, 2020 1:24 pm I got mine off eBay Ian think it was about £25 posted on a 1" drive

New expert quality in uk amazon £30,70 in german amazon £ 25 postet. Price in uk seems high in that moment

Fwiw, 55mm socket works just as well at half the price.